Montage Professional Speaker Cabinet Paint BLACK 5 Litre (6kg) Developed specifically for speaker cabinet manufacturers that are looking for an easy to apply coating that offers high protection and a professional finish. Montage Cabinet Paint provides a hardwearing, tough spatter finish that has excellent texture and offers excellent durability. Montage Cabinet Paint is an acrylic primer and topcoat in one, designed for over-coating a wide variety of substrates. This water borne finish which is based on a high-performance self cross-linking acrylic resin, is safe of use and has no strong odours. It is quick drying and easy to apply whilst providing good coverage and texture. Features Single pack Textured eggshell finish Water Based Very hard wearing and durable Very fast drying Excellent application direct to plywood, MDF and Chipboard, (spray, roller or brush) and pre painted surfaces Low odour Environmentally Friendly Montage Cabinet Paint provides excellent adhesion, UV resistance and will impart superior chip and scratch resistance. It provides a spatter finish which is durable, protective and decorative finish for many surfaces. Limitations Not suitable for structures where existing paint is flaking, cracking, or other failure. (Please contact Aquatec for details of appropriate systems) Performance of coating is reliant on correct preparation and application Surface Preparation New Surfaces • Surfaces should be free of grease, oil, salts and other contaminants before application. • Detergent wash if necessary, followed by a clean water rinse, preferably with a power washer. • Surfaces should be dry before ShieldTec AC-206 is applied. Existing Coatings • Test adhesion of the existing coating to the substrate. • Test overall thickness of coating to substrate. • For loose, flaking or otherwise defective areas, carefully remove to a firm edge. • Abrade gloss-coated surfaces to provide a key. • For retained coatings, thoroughly clean to remove dirt, grease and contaminants. • Surfaces should be dry before Montage Cabinet Paint is applied. Pretesting It is recommended that a test area be treated to ensure compatibility with, and adhesion to existing system. Mixing One pack system. Stir well before use. Application Conditions Min ambient temperature: 8°C Min substrate temperature: 8°C Max substrate temperature: 40°C Max relative humidity: 60% Recommended optimum conditions for speedy drying: Ambient temperature 20°C at relative humidity below 45%. Application Instructions Follow surface preparation instructions and ensure application conditions have been met. For best application apply Montage Cabinet Paint using conventional or compliant air spray equipment. Drying Times Dust Dry 20 Minutes Touch Dry 30 Minutes Tack Free 40 Minutes Fully Cured 24 Hours For a smooth finish apply as follows: Application Method Convetional or Compliant Thining 5 – 10% cold water as required Tip Size 1.8 – 2.0 mm Spray Pressure 55 – 65 ps Number of Coats 2 – 3 WFT per Coat 100 – 200 microns DFT Per Coat 50 – 100 microns Coverage per Coat 10 sq. metres per litre at 100 µm WFT For a spatter finish apply as follows: Application Method Convetional or Compliant Thining 5 – 10% cold water as required Tip Size 1.8 – 2.0 mm Spray Pressure Reduced as required to achieve desired effect Number of Coats 2 – 3 WFT per Coat Adjust as required to achieve desired effect DFT Per Coat Adjust as required to achieve desired effect Coverage per Coat – Clean-Up Equipment should be cleaned immediately with water. Dried paint may be removed with aromatic or oxygenated solvents. Storage Store between 5°C and 30° C. Maximum storage period is 6 months in original containers. Packaging Packed in 5 containers. Safety Information Wear suitable protective clothing. Avoid splashing on to bare skin and eyes. Always refer to the Health and Safety Data Sheet before use.
